Because US Armor's sizing specifications change from time to time, we strongly suggest that these concealable carriers should only be purchased to match existing ballistic panels. Without doing this, we have found that all too often the sizes will be off and not match the panels they were intended for.
If at all possible, please enter the serial numbers of your US Armor ballistic panels in the fields provided above to ensure a perfect fit.
The HVC interior area is constructed with a Wikaway® moisture management system. This fabric allows moisture to be 'wicked away' from the skin and into the fabric, greatly enhancing officer comfort and decreasing heat stress. This carrier is to be used with US Armor Enforcer vests.
When ordering the HVC Carrier make sure you have already purchased one of the Enforcer Vests and order a similar size to what US Armor vest you own. If your US Armor was custom made you may also order by calling in and providing the serial numbers of your ballistics.
Some armor has default vest sizes. Using a sizing chart you can estimate the closest generic size, however ordering with a sizing form will always give you the most accurate sizing.
Female vests should always be ordered with a sizing for a proper fit. In some cases male vests could be used, but it is usually not recommended.
To estimate your size to the closest generic vest size:
Measure your chest and add 2, i.e. 40+2=42.
Measure your waist and add 6, i.e. 38+6=44.
Pick the larger of the two, in this case 44.
If you have more than 6 between these two numbers average them out and if necessary round up to the nearest even number, i.e. 48μ40=44.
Measure your front length while sitting.
(Clavicle to above the navel)
13 to 14 = R and 15 to 16 = L
If your vest rises up when sitting, the SSBS Neoprene straps can be trimmed to raise the vest.
NOTE: In this case, please call us so as not to damage the product and void your warranty.
Understand that these are estimations for a quick fit; for a proper fit, it's always best to order with a sizing form. The professionals at Vantage Armor can walk you through the process if you have any questions.
How to tell if your concealable body armor fits correctly: Concealable body armor should cover your center mass vitals, and achieve anywhere from a 2-inch gap on each side (for the most mobility) to overlapping of the ballistic panels on the sides where the front and back panels meet (for the most protection).
The first thing to remember when trying on vests is that your front panel should always lay over your rear panel as threats typically come from in front of you, and this ensures that the overlap on the side of the vest is rear-facing.
A correctly sized vest will cover you from 1-1.5 inches below the top of your breastbone to 1-2 inches above your navel (belly button) in length. The width, as mentioned earlier, should achieve anywhere from a 2-inch gap to 1" of overlapping where the front and rear panels meet. Your personal preference may dictate minor variations in comfort, mobility, concealment, and protection.
A vest that is too small for the user will lack the needed coverage to ensure proper protection with large gaps of coverage as well as being too tight and constricting, whereas a vest that is too large will shift, bunch, and crumple while it's being worn, causing pinch points and poor protection. It is a crucial step when buying body armor to ensure that it fits properly so that it performs at its peak level.
If you have any questions at all about armor sizing, don't hesitate to call us. Our highly trained staff will assist you in getting the best fit possible.
For charts, choose from one of our available sizing charts below.
